Forum Replies Created
-
Posts
-
Heyo Greg. Yup I made sure I appear in skeleton skeleton and I see my feet, mid sectio and my hands in VR, I am able to move my hands in stuff in VR and with the PSMOVE. The PSmove controllers are both paired, set up and ready to go, I do the normal calibration portion.
As for the assign each tracker how do I do that part?
After being told by Greg in response to my question on YT to make a new post on the forums about my issue and I would receive help and after waiting my response is the following.
I did the room calibration with steam, then did the PSmove calibration with each controller, And then calibrated the Riftcat headset to the Kinect. I did try to manually set the buttons but now I just jump in place unable to move :/
I am running into a weird issue now. So I have set up Steam VR to in place tracking, I have the height set to my height in game, but now my character just runs around by it self not listening to the control sticks if I press the sticks it will change directions but by default my character is always walking around. I have tried removing the batteries from the controllers while in game one then the other to see if maybe it’s the controllers but that didn’t help. I pressed the grip buttons and got my arms tracked semi properly though so things are moving in the right direction 😀
I am about to sound like a total green horn but what do you mean by Calibrated on center? As for the Height I keep running into an issue with my camera being SUPER low like between my legs. As for Triggers I am using RiftCat so I have a Phone, a case and some cheap Bluetooth controllers I bought off amazon do you mean the triggers on it?
Hey I am running into the same issue but I am using RiftCat and a Kinect 360. How do I calibrate with this setup? Like I built this whole thing just to play VRchat and I am so close to finally being able to use this setup but I can’t figure out the last part
I am suing RiftCat and a HTC One M9 will this still work? I am facing issues with it getting past calibration all it does is repeat “It seems HMD is not tracking. Please check and resume calibration” no matter what I try I can’t get passed calibration any idea what is causing the hold up.