Homepage Forums How-to and troubleshooting kinect v1 flashing green light and not detected

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #11564
    Joshua GrossJoshua Gross

    when I plugged in my kinect V1 (360) and installed all the drivers for it, the light on the front kept flashing. This is fine, using the kinect SDK I tested it and verified it was tracking almost 100% accurately, with the only problems being when I wasn’t 100% in view of it, it would send my skeleton onto the nearest human-looking object, usually an object of clothing. Didn’t care about this. However, whenever I go into the config for Driver4VR to set up gestures and stuff for tracking without controllers, it tells me that the kinect isn’t running. Anyone know what to do about this? Thanks?
    (if it helps, these are my specs)
    8GB RAM
    GTX 1060 3GB

    Joshua GrossJoshua Gross

    just for an after comment
    at some random point, the headset began tracking correctly. The two controllers however appear absolutely miles away and still will not accept hand gesture inputs.
    my kinects light is still flashing.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.